30 Watt Mono-crystalline Portable Briefcase Solar Panel 12V Charger – temper proof glass
admin | August 11, 2010 | 5 comments |
- Thin Briefcase case design. Can be placed very easily underneath the seat of cars
- Powerful 30W output at 12V to recharge laptop computer, cell phones, IPod etc.
- Comes with an optional 12V, 9V, 6V, and 3V output voltage adapter, strong temper proof glass
- Assembled professionally with Siemens Mono-crystalline solar cells (in worldwide shortage)
- Comes with optional 7A battery charging controller for recharging 12V car type battery.
Additional / b
30 Watt Mono-crystalline Portable Briefcase Solar Charger 12V. If you need to use it to recharge a car battery, you may need a charge controller to prevent battery against overload. It comes with the 3V, 6V, 9V, 12V Power Adapter (thru. different contacts) in order to provide the selected voltage. In addition, the new model of mood-proof glass that is 17 times stronger than ordinary glass bryta.Löstagbara connections included: alligator. . . Learn more>>
30 Watt Mono-crystalline Portable Briefcase Solar Panel 12V Charger – temper proof glass
Category: Solar Panels
I was a little skeptical on these boards when I tested originally, but finally made good. I use it to recharge my power Duracell 600hd power and fully charged in 4-5 hours. I noticed that you do not need sunlight to make this committee work, but more sunlight increases the production of course. Not to use this panel to the AC power electronics is not designed for that. My UPS is used only 15 watts AC or a CFL bulb 13Watt. It is also good to recharge cell phones, or just under 15 watts. On the negitive side I have not tried it in wet weather and I do not think I’ll water it is not sealed very well and I have found so far is to support the group is not very robust and could not keep the amount of wind.
Rating: 4 / 5
After much research I bought this board six months ago. I used a lot in finding the power of my laptop computer and radio equipment (back row) systems, and run a 12V AA Battery Charger for LED lighting. With most of my fieldwork in Nevada, Utah and Arizona, we can intense sun radiation, this panel has done much for my needs and expectations. My panel provides an output design specifications.
In operation, I run all my equipment off a battery Optima Yellow Top deep cycle. My laptop and radio to get more than what this panel can provide, but because I run my laptop and radio only about 25% of the time, the panel is set up well with all my needs. Recently I used the panel for one week at the Grand Canyon. I was impressed, he has kept my battery level sufficient to operate my equipment even in a few cloudy days easy.
When it comes to durability, I recently passed the panel (when it was opened) and glass to the bottom. To my great relief survived Council to place without apparent damage or electric. Like the previous speaker did, it seems a little easy, but is in use, they seem to be holding up well.
I give this one 30W panel marks – it meets my needs quite well.
Rating: 5 / 5
Not a bad sign. It has mono-crystalline cells Siemens (36) and hard glass. The case is plastic but quite solid. The solar cells are mounted in EVA in the greenhouse. connector accessories are very well thought out with a charge controller, plugs cars, battery contacts and a reduction in tension development of lower voltage devices. Propylene is not well designed, but I generally do not use them anyway, this panel simply accessories cons almost nothing and no picture. A little heavy at 9 pounds of solid construction. The 30 Watt will charge any small device like a laptop or AA-charger also charge a car battery with a beautiful sunny day.
The above review is a mistake Coleman recommended that the Panel. The Coleman cheaper amorphous cells with only a fraction of the power not to charge a laptop and is also manufactured in China. Reviewers seem to have seen the 30 watt panel before commenting.
Rating: 4 / 5
I wanted this product so I like to help any attempt to decide to sell solar products. I tried to see where this is done, nobody was on the device itself or the literature says. I’m curious because I think it is set up by a guy in his garage from the platform parts. With the exception of a few weaknesses (it does not close properly and can be dangerous pinch cable if you’re not very careful) but it produces decent power.
However, if this has been done in some big factory in China, there are products available for much more money (the Brunton 26 Watt is excellent).
Rating: 3 / 5
Unfortunately, for the price you pay This product is a horrible waste of money. Made in China “is the theme here and it shows everywhere. Save your $ and look at Coleman CL1300 12 volt 20 watt solar panel battery charger that far exceeds the value and quality. Believe me do not spend your money on this!
Rating: 1 / 5